2-252
Catalyst 2350 Switch Command Reference
OL-19055-01
Chapter 2 Catalyst 2350 Cisco IOS Commands
show diagnostic
Command History
Usage Guidelines
The
show diagnostic post
command output is the same as the
show post
command output.
Expressions are case sensitive. For example, if you enter
| exclude output
, the lines that contain
output
do not appear, but the lines that contain
Output
appear.
Examples
This example shows how to display the online diagnostics that are configured on the switch:
Switch>
show diagnostic content
:
Diagnostics test suite attributes:
B/* - Basic ondemand test / NA
P/V/* - Per port test / Per device test / NA
D/N/* - Disruptive test / Non-disruptive test / NA
S/* - Only applicable to standby unit / NA
X/* - Not a health monitoring test / NA
F/* - Fixed monitoring interval test / NA
E/* - Always enabled monitoring test / NA
A/I - Monitoring is active / Monitoring is inactive
R/* - Switch will reload after test list completion / NA
P/* - will partition stack / NA
Test Interval Thre-
ID Test Name Attributes day hh:mm:ss.ms shold
==== ================================== ============ =============== =====
1) TestPortAsicStackPortLoopback ---> B*N****I** not configured n/a
2) TestPortAsicLoopback ------------> B*D*X**IR* not configured n/a
3) TestPortAsicCam -----------------> B*D*X**IR* not configured n/a
4) TestPortAsicRingLoopback --------> B*D*X**IR* not configured n/a
5) TestMicRingLoopback -------------> B*D*X**IR* not configured n/a
6) TestPortAsicMem -----------------> B*D*X**IR* not configured n/a
This example shows how to display the diagnostic test results on a switch. You can also use the
show
diagnostic switch
command to display these diagnostic results.
Switch>
show diagnostic result
: SerialNo : XXXXXXXXXXX
Overall diagnostic result: PASS
Test results: (. = Pass, F = Fail, U = Untested)
1) TestPortAsicStackPortLoopback ---> .
2) TestPortAsicLoopback ------------> U
3) TestPortAsicCam -----------------> U
4) TestPortAsicRingLoopback --------> U
5) TestMicRingLoopback -------------> U
6) TestPortAsicMem -----------------> U
7) TestInlinePwrCtlr ---------------> U
This example shows how to display the running tests in a switch:
Switch>
show diagnostic status
<BU> - Bootup Diagnostics, <HM> - Health Monitoring Diagnostics,
<OD> - OnDemand Diagnostics, <SCH> - Scheduled Diagnostics
Release
Modification
12.2(46)EY
This command was introduced.
