Port Management
Error Recovery Settings
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
165
10
-
Port protection is not subject to VLAN membership. Devices connected to protected
ports are not allowed to communicate with each other, even if they are members of
the same VLAN.
-
Both ports and LAGs can be defined as protected or unprotected. Protected LAGs
are described in the
section.
•
Member in LAG
—If the port is a member of a LAG, the LAG number appears;
otherwise this field is left blank.
STEP 6
Click
Apply
. The Port Settings are written to the Running Configuration file.
Error Recovery Settings
This page enables automatically reactivating a port that has been shutdown because of an error
condition after the Automatic Recovery Interval has passed.
To configure error recovery settings:
STEP 1
Click
Port Management
>
Error Recovery Settings
.
STEP 2
Enter the following fields:
•
Automatic Recovery Interval
—Specify the time delay for automatic error recovery, if
enabled, after a port is shutdown.
•
Automatic ErrDisable Recovery
-
Port Security
—Select to enable automatic error recovery when the port has been
shut down for port security violations
-
802.1x Single Host Violation
—Select to enable automatic error recovery when the
port has been shut down by 802.1x.
-
ACL Deny
—Select to enable automatic error recovery mechanism by an ACL
action.
-
STP BPDU Guard
—Select to enable automatic error recovery mechanism when
the port has been shut down by STP BPDU guard.
-
STP Loopback Guard
— Enable automatic recovery when the port has been shut
down by STP Loopback Guard.
