IP Configuration
IPv6 Management and Interfaces
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
315
16
Enterprise Number
—If you select this option, enter the following fields.
-
Enterprise Number
—The vendors registered Private Enterprise number as
maintained by IANA.
-
Identifier
—The vendor-defined hex string (up to 64 hex characters). If the number
of the character is not even, a zero is added at the right. Each 2 hex characters can
be separated by a period or colon.
•
DHCPv6 Unique Identifier (DUID)
—Displays the identifier selected.
STEP 3
Click
Apply
. The IPv6 global parameters and DHCPv6 client settings are updated.
IPv6 Interfaces
An IPv6 interface can be configured on a port, LAG, VLAN, loopback interface or tunnel.
As opposed to other types of interfaces, a tunnel interface is first created in the
page and then IPv6 interface is configured on the tunnel in this page.
To define an IPv6 interface:
STEP 1
Click
IP Configuration
>
IPv6 Management and Interfaces
>
IPv6 Interfaces
.
STEP 2
Enter the parameters.
•
IPv6 Link Local Default Zone
—Select to enable defining a default zone. This is an
interface to be used to egress a link-local packet arriving without a specified interface
or with its default zone 0.
•
IPv6 Link Local Default Zone Interface
—Select an interface to be used as a default
zone. This can be a previously-defined tunnel or other interface.
STEP 3
Click
Apply
to configure default zone.
The IPv6 Interface Table is displayed along with the following field:
•
Tunnel Type
—Manual, 6 to 4 and ISATAP.
STEP 4
Click
Add
to add a new interface on which interface IPv6 is enabled.
STEP 5
Enter the fields:
•
IPv6 Interface
—Select a specific unit, port, LAG, loopback interface or VLAN for the
IPv6 address.
