Chevrolet BEAUVILLE SPORTVAN G10 SERIES, Service Manual

Page: 52 / 350

BODY 1B-5
■APPLY
SEALER
Fig. 7 —W indshield Glass, W eatherstrip and Sealing
3. Place protective covering over plenum grille, front fenders
and hood.
4. Place windshield and weatherstrip assembly in opening.
With one technician lightly pushing in on windshield,
another technician within the cab should pull on the cord
as follows:
a.
Pull on loose ends (fig. 9) until each is within 2" o f
its respective upper corner.
b. Pull on loop until cord is within 2" o f the upper
corners.
c. Finish seating corners by simultaneously pulling on
both ends o f the cord at each corner. This will
insure proper positioning o f the critical upper
corners.
d. Seal windshield to weatherstrip and weatherstrip to
body.
Fig. 9 —Pulling String to Seal R ubber Lip
Cowl Side Ventilator Valve Assembly (Fig. 10)
Removal
1. Remove screws retaining valve guide to panel.
2. Remove valve assembly by depressing pins at top and
b ottom o f valve.
Installation
1. Depress pins at top and bottom o f valve and insert into
panel.
2. Install screws retaining valve guide to panel.
Instrument Panel Trim
N O T E : Instrum ent panel trim consists o f fo ur
separate pieces. Each piece is retained by nuts under
the instrum ent panel. The follow ing procedure,
then, is typical.
Removal
1. From under the instrument panel, remove nuts retaining
the trim panel and its insert and remove trim.
2. Separate trim from insert.
Fig. 1 0 —Side Cowl V en tilato r
Pi i
1
forwaj
C H E V Y V A N S H O P M A N U A L