Canon VK-16 v2.0, Administrator'S Manual

Page: 128 / 302

128
Set Motion Detection Recording
Area Ratio marker.
Yellow color bar - Changed area is equal to or greater than the
specified
Area Ratio (activity peaks on or to the right of the Area
Ratio Marker) but the required cotinuance of motion has not met
the specified duration in order to trigger an event.
Red color bar - The amount of change that meets the defined
detection conditions and motion is detected, triggering an event,
i.e., the required amount of motion has been detected for the
specified duration.
Area Ratio marker.
Area Ratio marker.
The sensitivity can be set to Low - Med or Med - High. To set,
check the Detail Settings checkbox and click the Settings button.
When the Detail Settings dialog box is displayed, click Low - Med
to set the sensitivity in the range of 1 to 128, or Med - High to set
in the range of 129 to 256.
Tip
Although the duration for recognizing motion is fixed at 0.2
seconds, this can also be changed if neccesary. To change this
setting, select the Detail Settings checkbox and click the Settings
button. The Detail Settings dialog box is displayed, and the value
can be change in the range of 0.0 to 5.0 seconds.
Tip
●
Set the Sensitivity
Sensitivity is the degree of change which is detected as motion.
Drag the slide bar to adjust Sensitivity
to the required value. Can be specified
in increments of 10 from 1 to 250.
●
Set the Area Ratio
Area Ratio is the degree of change of area (ratio against the defined detection area)
detected as motion.
Click and drag the Area Ratio slide bar to
any position from 0% to 100%. This
establishes the proportion of image inside the
Active Region (dotted frame) allowed before
motion is detected.
When you drag the slide bar, the black vertical line in the Detection
Indicator will move to reflect the change in specified
Area Ratio .