Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 59 / 184

Chapter 2 Indexes by Case
2-47
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure
or tool)
2F2D Cassette not
working.
Turn off printer,
wait, then
turn on again.
Power
On
Again
Cassette
Motion
Error
Cassette operation disabled
A PWM duty of 100% has lasted for 200
msec in a cassette operation.
①
Check the
cassette motor
and the drive
circuit.
② Check the
cassette
encoder
sensor.
2F2E Hardware error.
03130031-2F2E
Turn off printer,
wait, then
turn on again.
Power
On
Again
Roll
Motion
Timeout
Roll shift timeout
No sensor has been detected during a roll
operation involving sensor detection.
Go to ★ 200C
(P3-8).
Non-ejection detection error
As a result of nozzle checking made by the
head management sensor unit:
①
All 640 nozzles in a nozzle line are
non-discharging.
② At least 50 nozzles have been found
mismatched in a nozzle line of 640 nozzles
since the last session of detection.
①
Check whether
any foreign
matter such as
paper slip
exists on the
head
management
sensor optical
axis.
②
Light
interception
due to ink
accumulation.
⇒
Remove the
ink/ Replace
the unit.
③ Check the
head
management
sensor’s
connector
connection
④
If Service
mode nozzle
check pattern
printing is no
problem,
replace the
head
management
sensor unit.
Go to
★
2F2F
(P3-6 ） .
2F2F Hardware error.
03800500-2F2F
Turn off printer,
wait, then
turn on again.
Power
On
Again
Eject.
Detect
Err
Reference 1) As for the detection condition
①
above, in the
iPF650/750, iPF6300/6350, and iPF8300 series or later, the error
codes are broken up into 2F40,2F41,2F42,2F43,2F44, and 2F47
depending on the non-ejection conditions.
Reference 2) Error 2F2F,2F40,2F41,2F42,2F43,2F44, and 2F47
are detected in the following order.
①
Determines signal level (2F47) of head management sensor
②
Determines complete non-ejection of all colors (2F40)
③
Determines multiple mismatches (2F2F)
④ Determines complete non-ejection of a single color (2F41)
⑤ Determines complete non-ejection of one line (2F42)
⑥ Determines complete non-ejection of 640 nozzles (2F43)
⑦ Determines non-ejection of more than 320 nozzles (2F44)
Reference 3) The amount of change (between non-ejecting and
ejecting nozzle counts) from the last session of nozzle checking is
defined as the amount of mismatch.
2F30 Hardware error.
xxxxxxxx-xxxx
Turn off printer,
wait, then
turn on again.
Non-ejection detecting position error
No detectable region has been found during
non-ejection position adjustment.
Go to
★
2F2F
(P3-6).