Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 24 / 184

Troubleshooting Guide
2-12
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure
or tool)
Cannot cut paper.
Press Load/Eject
and reload the
paper.
Cannot cut paper.
Reload the paper.
Cannot cut paper.
Lift the release
lever and reload
the paper.
2015
Paper cutting
failed. Lift the
release lever.
Cutting
Error
Please
Cut Papr
Press
↑
Key
to
Release
Paper
Cutting failure/jam detected due to a cutting
failure
An idle cutter unit or a cutter blade that is too
blunt to cut sheet has been detected by the
paper leading edge detection sequence.
Go to
★
2015
(P3-17).
Go to
★
2F24
(P3-18).
No sheets.
Press Load/Eject
and reload the
paper.
No sheets.
Lift the release
lever and reload the
sheets.
The paper is too
small.
Check paper size.
Sheet removed.
Lift the release
lever.
Sheets
Please
Load
Sheet Not
Loaded
Paper loosened out of position while printing
The trailing edge of paper has been detected
at least 20 mm shorter than the length of cut
forms detected.
Reload the paper.
Go to ★ 2E27
(P3-14).
Paper jam.
Press Load/Eject and
reload the
paper.
Paper Jam
Press
↑
Key
Paper jam.
Manually rewind roll
all the way.
Paper jam.
Manually rewind roll
all the way
and press OK.
Cannot feed paper
Lift the release
lever and reload
paper.
Cannot feed paper.
Reload the paper.
2016
Cannot feed paper.
Press Load/Eject
and reload the
paper.
Paper Jam
Press ↑
Key
Paper
Eject Err
Remove
Paper
Jam while picking up, ejecting or printing on
paper
(A sequence of removing jams with the pinch
roller released is required)
Virtually all recovery errors that could occur in
connection with paper pickup are handled.
①
Open and
close the
release lever to
reload the
paper.
②
Remove the
paper once
and then
refeed it.
★
Go to 2E27
(P3-14)