Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 19 / 184

Chapter 2 Indexes by Case
2-7
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure
or tool)
1049 Before borderless
printing, move the
blue platen switch.
When print data with borderless printing
specification has been received, platen
shutter was closed.
Open the platen
shutter.
1050 Blue platen switch
is dirty. Please
clean the switch.
Cleaning of platen shutter is necessary.
When reading the platen shutter in
multisensor, borderless printing data has
been received in unstable output condition.
Clean the platen
shutter.
1051 Paper Too Small Paper mismatch (size)
Size clip warning
With [Warning Indication] selected for [Paper
Mismatch Detection] in the menu settings,
the size of paper loaded is smaller than that
of specified from driver.
Continued printing
allowed.
Check driver
settings.
Replace with
appropriate paper.
1052 Borderless printng
not possible. Check
supported paper.
Borderless printing not available
(unsupported size)
With [Warning Indication] selected for [Paper
Mismatch Detection] in the menu settings,
borderless printing data is received, but roll
paper not supporting borderless printing has
been loaded.
Replace with
appropriate paper.
1053 Paper position not
suitable for
borderless printing.
Borderless printing not available (physical)
With [Warning Indication] selected for [Paper
Mismatch Detection] in the menu settings,
borderless printing data is received, but roll
paper loaded is more than 1mm off the
predefined position for the pre-ejection
opening at the counter-HP side.
Reload/ replace
the roll paper.
Go to ★ 2010
(P3-12)(iPF8300
series).
1053 Borderless printng
not possible. Check
pap. pos. or spacer
Reload/ replace
the roll paper.
Check the
borderless spacer.
Go to
★
2010
(P3-12)(iPF6300
series)
1054 PaprWidth Mismatch Paper mismatch (size)
With [Warning Indication] selected for [Paper
Mismatch Detection] in the menu settings,
the width of roll paper loaded and that of
specified by data do not match.
Continued printing
allowed.
Check driver
settings.
Replace with
appropriate paper.