Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 56 / 184

Troubleshooting Guide
2-44
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure
or tool)
2F22 Hardware error.
03130031-2F22
Turn off printer,
wait, then
turn on again.
Power
On
Again
Pump
Motion
Timeout
Pump shift timeout
The target position could not be reached
within a predicted operation time + 3
seconds during pump operation or no
sensor has been detected during a pump
operation involving sensor detection.
<Supplement>
・
If the carriage
travels heavily
towards the
stop position: A
mechanical load
error may be
suspected.
・
Otherwise: The
sensor in the
purge unit may
be at fault.
Go to
★
2F1F(P3-2).
2F23 Hardware error.
03130031-2F23
Turn off printer,
wait, then
turn on again.
Power
On
Again
Pump
Motion
Error
Purge motor error
Pump operation disabledA PWM duty of
100% has lasted for 200 msec in a pump
operation.
<Supplement>
・ If the motor
could not be run
at all or has
resulted in an
error after
moving by a
slight distance:
A. A mechanical
load error may
be suspected.
B. The motor or
drive circuit
may be at
fault.
・
If the carriage
has run more or
less out of
control and
resulted in an
error:
A. The encoder
sensor may be
at fault.
Go to
★
2F1F
(P3-2).
2F24 Cannot cut paper.
Lift the release
lever and reload
the paper.
Cutting
Error
Please
Cut Papr
Press
↑
Key
to
Release
Paper
Cutter shift timeout
The cutter failed to reach the home position
in time during a cutting operation
Go to
★
2015
(P3-17).
Go to
★
2F24
(P3-18).
2F24 Hardware error.
03130031-2F24
Turn off printer,
wait, then
turn on again.
Power
On
Again
Cutter
Timeout
Cutter shift timeout error
No sensor has been detected during a cutter
operation involving sensor detection.
Go to
★
2F24
(P3-18).