Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 22 / 184

Troubleshooting Guide
2-10
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure
or tool)
Paper size not
detected.
Press Load/Eject
and reload the
paper.
200D
Leading edge
detection error.
Lift the release
lever and align
leading edge
with orange line.
Paper size not
detected.
Lift the release
lever and reload
the paper.
Paper size not
detected.
Reload paper.
Paper
Please
Reload
Size
Undetect
ed
Press
↑ Key
Paper size detection failure
Cannot detect the trailing edge of the paper.
・ Cannot detect the trailing edge of the cut
sheet loaded after they have been fed 50
mm.
・ Cannot locate the trailing edge of the paper
that has been found by coarse detection.
①
Check to see if
roll paper are
not loaded in
the cut sheet
mode.
② Load cut
sheet. Go to
★
2010
(P3-12)
This paper
cannot be used.
Check supported
paper sizes.
Paper
Size
Please
Check
Paper
Too
Small
Press
↑
Key
200E
This paper
cannot be used.
Check supported
paper sizes.
Load/Eject: Change
Paper
Paper
Size
Please
Check
Paper
Too
Small
Press
↑ Key
Paper is too small
The width and length of paper detected are
shorter than the supported size (1.5%
margin).
① Check paper
conditions
(soiling,
tear-offs,
residual paper
chips, residual
trimming cuts,
folds)/size.
② Has the paper
been fed
successfully
(without
slippage under
a load or any
influence)?
③
Has the LF
adjustment
value set
correctly?
④
Hasn’t the
loaded paper
shrunk to
below its
margin in the
particular
environment?
Go to ★
2017/2018 (P3-12)