Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 52 / 184

Troubleshooting Guide
2-40
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure or
tool)
Cannot load.
Press Load/Eject
and reload the
paper.
Cannot feed paper
Lift the release
lever and reload
paper.
Cannot feed paper.
Reload the paper.
Remove
paper
Cannot
Feed
Press
↑ Key
Feeding error (nip release required)
LF out of synchronization (LF motor
won’t rotate) has been detected.
★
Go to
2E27(P3-14).
Paper jam.
Press Load/Eject
and reload the
paper.
Paper jam. Lift
the release lever.
Paper jam.
Push the release
lever back.
Paper jam.
Manually rewind roll
all the way.
2E27
Paper jam.
Manually rewind roll
all the way
and press OK.
Paper
Jam
Press
↑ Key
Jam while picking up, ejecting or
printing on paper
(A sequence of removing jams with
the pinch roller released is
required)(JAM1)
Virtually all recovery errors that could
occur in connection with paper pickup
are handled.
①
Open and close
the release lever
to reload the
paper.
② Remove the
paper once and
then refeed it.
★
Go to
2E27(P3-14).
2E30 The paper is
too small.
Paper mismatch (size)
With [Pause] selected for [Paper
Mismatch Detection] in the menu
setting, paper size for the paper
loaded was smaller than the size
specified by data.
Continued printing
allowed.
Check driver setting
Replace with
appropriate paper.
2E31 Insufficient paper
for job
All of the following conditions have
been met at the start of external
printing:
・ [ON] has been selected for
[Remaining Roll Paper Detection].
・
Among the paper size settings
coded in the print data, the paper
length exceeds the remaining
length of roll paper.
・
Automatic roll feed to another roll
paper slot which is not the current
feeding path, out of the 2 slots the
printer has, is not available.
Replace the roll
paper.
2E32 Insufficient paper
for job
All of the following conditions have
been met at the start of external
printing:
・ [ON] has been selected for
[Remaining Roll Paper Detection].
・
Among the paper size settings
coded in the print data, the paper
length exceeds the remaining
length of roll paper.
・
Automatic roll feed to another roll
paper slot which is not the current
feeding path, out of the 2 slots the
printer has, is not available.
Replace the roll
paper.