Canon imagePROGRAF IPF9000S, Troubleshooting Manual

Page: 26 / 184

Troubleshooting Guide
2-14
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(
★
: Reference fault
isolation procedure
or tool)
Paper size not
detected.
Lift the release
lever and reload
the paper.
Paper size not
detected.
Reload paper.
Papr Size
Undetecte
d
Press
Online
Key
and
Reload
Paper size not
detected.
Press Load/Eject
and reload the
paper.
Paper size not
detected.
Lift release lever.
Could not detect
paper size. Push
release lever back,
then pull out the
cut sheet.
2018
Could not detect
paper size.
Press OK, then
insert roll paper
straight into feed
slot.
Paper
Please
Reload
Size
Undetect
ed
Press
↑ Key
Paper (left) side detection error
The non-reference edge of paper has been
located by coarse detection but not by a
second round of fine detection.
Go to
★
2010
(P3-12)
Cannot cut paper.
Lift the release
lever and reload
the paper.
Cannot cut paper.
Reload the paper.
Paper cutting
failed. Lift the
release lever.
2019
Paper cutting
failed. Remove the
paper
after cutting at the
top of feed slot. Push
the release
lever back.
Cutting failure/jam detected due to a cutting
failure
An idle cutter unit or a cutter blade that is too
blunt to cut sheet has been detected by the
paper leading edge detection sequence. Or,
cutter unit home position detection was
failed.
Go to ★ 2015
(P3-17).
Go to
★
2F24
(P3-18).