Canon CXDI-1, Operation Manual

Page: 157 / 170

– 149 –
C. Using the Sensor Unit Attach/Detach Function
NOTE: This function can be used only with sensor units equipped with an attach/
detach function.
Be sure to also refer to the user’s manuals for both the sensor unit and power
box on the use of this function.
The procedure below is an example of operations when using the category type exposure screen.
C.1 Attach/Detach Function of the Sensor Unit
The sensor unit can be attached/detached while the system is running.
The procedure for attaching and detaching the sensor unit is simple.
NOTE: To attach/detach the sensor unit, always turn off the power of the power box
first.
NOTE: Do not remove the connector or disconnect the power of the power box while
image data is being transferred. Image data that has been taken will be lost.
NOTE: Always attach/detach the sensor unit from the exposure screen.
Attaching/detaching the sensor unit while on another screen may result in
malfunction or loss of data.
NOTE: If a dialog box is being displayed on the exposure screen, close the dialog
box first and then perform attachment/detachment.
NOTE: If the sensor unit is detached during READY status, READY status will be
canceled, and the selected exposure mode and parameters set on the
parameter changing screen will become disabled. To continue taking
exposures, select the exposure mode and make settings again (
→
page 15)
after connecting the detached sensor unit.