User Manual – Rev B
FCS Series II
400Hz
VFREQ
60 Hz
1 393
360
59
1
minute
2 407
800
61
1
minute
3 400
SSF
60
1
minute
Table 10-2: Steady state frequency
The
VOLT UNB
A
se only in the following sequence:
The tes
.
The
←
key (backspace) will termi
PHASE DIFFERENCE
This test applies to three phase systems onl
If ph
°
for 1 minute
VOLTAGE MODULATION
±
2.5V rms over a period of one second. The test will last
for
i
ackspace) will terminate the test at any time.
FREQUENC M
←
key (backspace) will terminate the test at any time.
AL NCE
This test will change the output voltage for the selected pha
•
112V for 1 minute.
•
118V for 1 minute.
•
115V for 1 minute.
t will be repeated on three phase systems to include all three phases if the coupling is set to all
nate the test at any time.
y. The phase angle for the selected phase will
change relative to phase A in the following sequence:
If phase B is selected:
•
236
°
for 1 minute.
•
244
°
for 1 minute.
•
240
°
for 1 minute.
ase C is selected:
•
116
°
for 1 minute.
•
124
°
for 1 minute.
•
120
This test will vary the output voltage by
2 m nutes. The
←
key (b
Y
ODULATION
REVISION
D
E
F (400Hz /VFREQ)
F (60HZ)
MODULATION
±
7Hz
±
4Hz
±
4Hz
±
0.5Hz
Table 10-3: Frequency Modulation
t will vary the output frequency as defined by
This tes
Table 10-3 over a period of one minute.
The s
inate the test at any time.
WAVEF
te t will last for 4 minutes. The
←
key (backspace) will term
ORM DISTORTION
California Instruments
133
Summary of Contents for FCS Series II
Page 4: ...User Manual Rev B FCS Series II California Instruments 4...
Page 27: ...User Manual Rev B FCS Series II California Instruments 27...
Page 89: ...FCS Series II 89 Figure 5 1 FCS System Block Diagram User Manual Rev B California Instruments...
Page 95: ...User Manual Rev B FCS Series II Figure 6 1 Calibration Setup California Instruments 95...
