User Manual – Rev B
FCS Series II
synchronization may get lost d
transient state machine.
ue to timing skew between the waveform generator and the
4.7.8 T
Figure 4-13: Switching Waveforms in a Transient List
ransient Execution
Figure 4-14: TRANSIENT Menu
A transient list can be executed from the TRANSIENT menu. To start a transient list, posit
cursor on the TRAN ST field as shown in Figure 4-14 and press the ENTER key. Transients
may be aborted by pressing the ENTER key again while on the same field
ion the
as the field changes
nsients, this will likely
Longer duration
e aborted in this fashion.
4.7.9 Saving Transient List Programs
to ABORT while a transient execution is in progress. For short duration tra
not be visible, as the transient will complete before the screen is updated.
transients however may b
When the AC source is turned off, the transient list that was programmed is not automatically
retained. Thus, if you turn the unit off, you will loose your programmed transient list. However,
transient programs may be saved in nonvolatile memory for later recall. This allows multiple
transient list programs to be recalled quickly without the need to enter all parameters each time.
Transient lists are stored as part of the overall instrument front panel setup in any of the
available setup registers.
created in the previous example, proceed as follows:
To save the transient list you
1. Press
the
Menu
key repeatedly until the REGISTERS / CONFIGURATION menu is
displayed.
2. Move the cursor to the REGISTERS entry and press the ENTER key.
3. The cursor will default to the SAVE REGISTER # position. Enter a number from 1 through
egister you selected.
15 and press the ENTER key.
DO NOT USE REGISTER 0 (REG0)
as it is reserved for
power-on setting recall and does not include a transient list.
4. A message will appear indicating that the front panel settings and the transient list data have
been saved in the setup r
California Instruments
85
Summary of Contents for FCS Series II
Page 4: ...User Manual Rev B FCS Series II California Instruments 4...
Page 27: ...User Manual Rev B FCS Series II California Instruments 27...
Page 89: ...FCS Series II 89 Figure 5 1 FCS System Block Diagram User Manual Rev B California Instruments...
Page 95: ...User Manual Rev B FCS Series II Figure 6 1 Calibration Setup California Instruments 95...