California Instruments FCS Series II, User Manual

Page: 101 / 210

User Manual – Rev B FCS Series II
4. Select this function by p
point to OUTP CAL. Pre
ressing the cursor until the arrow on the right side of the display
ss the ENTER key.
5. A Calibration Password (CAL PWORD) will be required. The password will be the value
the high voltage range. Enter this va ront Panel encoder and press the
6. Select Phase A and check the output e should be
450 for both standard FCS II models. (Refer to table below). If not, adjust as needed
y.
7. Select Phase B and check for the corr
entry for Phase C. Make s key is pressed each time a value
t to the factory default setting to store this value
9. If three-phase mode is available, select the three-phase mode from the
CONFIGURATION menu. If the Ls unit has one-phase only, adjust only phase A.
lect the Low Voltage range.
roll to mode by
ogra l three phases
spe
12. Close the output relay.
e external AC DVM to the respective output and use the adjustment indicated
±
0.115 volts.
peat for Phase B and C as needed
one.
of lue with the F
ENTER key.
calibration coefficient setting. The valu
and press the ENTER ke
ect value or set it as needed.
8. Repeat the ure the ENTER
has to be rese
10. Se
11. Select the SETUP screen and sc
selecting OFF and then set the p
the ALC setting entry. Turn o
m value for the output voltage
ff the ALC
r
to 115.00 volts and 400 Hz with re
for al
ct to Neutral.
13. Connect th
below so set the output voltage to 115
14. Re .
15. Open the output relays when d
Output
Phase
OUTP CAL value Current Limit
Board
Adjustment Pots
Standard
A or 1 R1 450
B or 2 R2 450
C or 3 R3 450
Table 6-3: Output Calibration Co lts. efficients - Factory Defau
California Instruments 101