User Manual – Rev B
FCS Series II
9. Option –160: RTCA/DO-160 Rev E Tests (Software)
U
•
-160 option. Options installed are listed on unit’s serial tag or shown on Configuration
screen.
•
Windows XP/2000 PC with RS232C, LAN or National Instruments GPIB controller
interface. California Instruments recommends the use of the GPIB interface for best
performance.
vionics Software user manual (CI P/N 4994-971) for operating instructions for all
GUI based test options. This manual is distributed in PFD format on the same CD as this user
manual. (CI P/N CIC496).
se of this option requires the following:
•
FCS Series
•
LxGui Windows software revision 1.14 or higher. Provided on CI P/N CIC496 CD ROM
or available for download from California Instruments’ website.
•
For specific tests, additional test equipment may be required to perform all section 16
tests.
Refer to the A
his DO160 Rev E implementation uses arbitrary waveform capabilities and harmonic measurements, both
require the –ADV (advanced features) option on the FCS Series II. Contact California Instrumen
1
Note: T
of which
ts for
information on upgrading FCS Series II models with the –ADV option.
California Instruments
128
Summary of Contents for FCS Series II
Page 4: ...User Manual Rev B FCS Series II California Instruments 4...
Page 27: ...User Manual Rev B FCS Series II California Instruments 27...
Page 89: ...FCS Series II 89 Figure 5 1 FCS System Block Diagram User Manual Rev B California Instruments...
Page 95: ...User Manual Rev B FCS Series II Figure 6 1 Calibration Setup California Instruments 95...
