BYD F3DM, Owner'S Manual

Page: 136 / 214

- 136 -
F3DM Owner’s Manual
Before Starting the DM
System
1.Check if the car is in charging, if so,
turn off the power, take off the charging
cable and keep it properly.
2.Make sure all windows mirrors
,and outside lights are clean and
unobstructed .
3.Check the area around the vehicle
before entering it, such as snows,
puddle, space and barrier.
4.Visually check the tires. If a tire looks
low, use a gauge to check its pressure.
5.Adjust seat position and height,
seatback angle, waist-holding angle,
head restraint height and steering
wheel angle.
6.Check the steering wheel adjustment.
(see section 1-3 “Steering Wheel”).
7.Lock up all doors.
8.Fasten seat belts.
How to Start the Car
Please follow the procedures below:
Step 1: Lift the anti-theft system.
Once you set the anti-theft system
by pressing “LOCK” on the wireless
remote control, you must press
“UNLOCK” to cancel it before driving,
or you cannot start the car.
Step 2: Turn the ignition switch to
“ON” to start the car, and then the
instruments will check automatically.
Before starting the car, make sure the
transaxle is in “P” or “N”position.
Step 3: Check if there is any warning
information on instruments display, If
yes, please carry out car examination
refer to section 1-5.
Step 4: Adjust the inside and outside
rear-view mirrors of the car.
Step 5: Make sure all doors had been
lock up and seat belts were fasten.
Step6: Depress the brake pedal and
shift the transaxle to D or R position.
And make sure the instruments display
D or R position.
Step 7: Release the parking brake.
Step 8: Release the brake pedal
gradually, and rest your foot on
accelerator pedal lightly to accelerate
the vehicle.
NOTICE
Make sure procedure in “Before
S t a r t i n g t h e D M S y s t e m ” i s
performed before starting the DM
system
使用手册小330.indd 136 2011-4-13 18:36:51