6. Replacing Parts
6-1-13. Carriage Driving Parts
0186Y
Disassembling
1.
Turn ON the printer, lower the Caps and turn OFF the printer. (Refer to “3-1-5-3. Output Check”.)
2.
Remove the Cover Cartridge and lift up the Cover UB. (Refer to “6-1-2. Assembling/Disassembling of the
Covers”.)
3.
Loosen the Bolt Socket (1) and remove the Bolt Socket (2).
<Note>
Confirm the Belt tension before you loosen the Bolt Socket (1) when you re-use the Belt after adjustment.
(See the process of adjustment in the next page.)
4.
Loosen the Bolt Socket (3) and remove the Bolt Socket (4).
If you replace the Belt only, disassembling is finished here. Go to the step 4 in Assembling.
5.
Disconnect the Connector (A) of the Motor.
(A)
6.
Remove the Bolt Socket (5) and remove the CR Drive Unit ASSY (6).
7.
Remove the Bolt Socket (1) and remove the CR Follow Unit Assy (7).
GT-3 Series
155