BouMatic Robotics MR-D1, Service Manual

Page: 327 / 446

Maintenance
Service: Continuation 1
23 June 2015 Version 1.7 Page 24-15
STEP ACTION
Figure 24-22 Clamping block milking cup front at the pulley
6. Fix the new tooth belt at the clamping blocks (1) (see Figure 24-22 ).
NOTE : at all clamping blocks the tooth belts protude about (see Figure
24-23 ).
Figure 24-23 Tooth belt in clamping block
7. Place it around the pulley (2) (see Figure 24-22 ).
8. Tighten the tooth belt at the clamping blocks (1) (see Figure 24-21 )
that are located in the shaft at the upper side of the milking box.
9. Follow step 10 until 14 to replace the tooth belts milking cups rear.
10. Unscrew the bolts of the clamping blocks (1) (see Figure 24-24 ) at the
upperside of the milking box.
1
2
1 cm