Biotek Synergy HTX, Operator'S Manual, Page: 179 / 184

Error Codes |
155
Code Description and Probable Causes:
x=7: Plate width < 84.15 mm or > 86.11 mm
x=8: Plate length < 125.73 mm or > 128.40 mm
Review definition for plate defined in Plate Type database. Ensure counts or
dimensions do not exceed limits. See the Gen5 Help for a description of
measuring plates.
2B0x Syringe failure.
x=1: Syringe failed to reach home sensor (optical sensor should be on).
x=2: Syringe moved off home sensor, but sensor didn’t changes state (optical
sensor should be off).
x=3: Syringe clean position too far from home sensor.
x=4: Steps to clear sensor at runtime deviated from value saved when homing
(verify error).
Protocol definition is incorrect or reader is being controlled by incorrectly
programmed third-party software.
Syringe was not installed correctly or was not cleaned, preventing a move to
home sensor.
Contact BioTek TAC.
2B0A Plate not in carrier for system prime operation.
Place priming plate in carrier.
2C01
2C05
2C07 Dispenser configuration incorrect.
Volume calibration data is invalid.
Volume calibration is needed to override defaults.
Verify that the dispenser calibration values have been loaded into Gen5. See
the Installation chapter in the Synergy HTX Operator’s Manual .
Contact BioTek TAC.
2D09 Tip prime volumes specified could overflow the tip priming trough.
Empty the tip priming trough. Contact BioTek TAC.
2D0A Tip prime trough or plate is full or may overflow.
Empty the tip priming plate.
2D15 Invalid kinetic interval selected for plate mode/plate synchronous mode.
Enter a valid kinetic interval. Call BioTek TAC.
2D16 Assay missed scheduled start of read (well synchronous mode).
Verify computer setup. Hibernate or sleep mode should not be enabled.
Contact BioTek TAC.
2D22 Invalid volume selected for tip prime.
Select a valid volume. Call BioTek TAC.
2D23 Invalid volume selected for dispense.
Select a valid volume. Call BioTek TAC.
Synergy HTX Operator’s Manual