3500/42 Operation and Maintenance
Maintenance
93
Transducers can be connected to a 3500 rack in a variety of ways. Depending
on the wiring option for the I/O module of your monitor, connect the test
equipment to the monitor using one of the following methods:
5.1.4
Using the Rack Configuration Software
The laptop computer that is part of the test setup uses the Rack Configuration
Software to display output from the rack and to reset certain operating
parameters in the rack. To perform the test procedures in this section you must
be familiar with the following features of the Rack Configuration Software:
- upload, download, and save configuration files
- enable and disable channels and alarms
- bypass channels and alarms
- display the Verification screen
The Rack Configuration and Test Utilities Guide (part number 129777-01)
explains how to perform these operations.
Note
It is important to save the original rack configuration before doing any
Maintenance or Troubleshooting Procedures. It may be necessary during
these procedures to change setpoints, etc. which must be restored to their
original values at the conclusion of the procedures. At that time the original
configuration should be downloaded to the rack.
Connect test
equipment
here.
Proximitor/Seismic I/O Module
and Internal Barrier I/O Module
(Internal Termination)
External Termination
Block (Euro Style
Connectors)
External Termination
Block (Terminal Strip
Connectors)
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
