Beijer Electronics korenix JetWave 3220v3 Series, User Manual

Page: 72 / 141

JetWave 3220v3/3420v3 Series User Manual
Page 63
Wireless Mode: The below operating modes are available on this AP/Gateway.
AP: The AP works as the Access Point mode, it establishes a wireless coverage and receives
connectivity from other wireless clients devices, the clients can search and connect to it. In
Wireless AP mode, you can configure the Wireless Network Name (SSID), Enable/Disable
Broadcast SSID, select the 802.11 mode, HT Protect Enabled/Disabled, Frequency/Channel,
Maximum Output Power (per chain), Data Rate and Extension Channel Protection. While the
Wireless Client connect to the AP, the client must follow AP settings for communicating.
Wireless Client: The AP/Gateway is able to connect to the AP and thus join the wireless network
around it. In Wireless Client mode, you can click "Site Survey" to find the best signal connected
AP per your need. Or you can manually type the SSID you want to connect.
WDS-AP: WDS mode is usually implemented in Point to Point (P2P) connection. When configuring
P2P, one end should be WDS-AP and the other end should be WDS-Client. WDS-AP can also
provide network access to general clients to act as an AP repeater.
WDS-Client: Select the WDS-Client mode. In WDS-Client mode, you must type the target WDS-
AP's SSID and MAC address. With the setting, the traffic from the WDS-Client can Only transmit
to the WDS-AP. Please note that the rest of other wireless/security settings must the same as the
WDS-AP as well.
JSM-AP : In JSM-AP mode, the JSM-AP will sync settings with JSM-Client automatic when config
changed. The sync range include SSID,802.11 Mode,BandWidth,Authentication(Open or
WPA2PSK),Encryption,WPA Passphrase.
JSM-Client: In JSM-Client mode, the JSM-Client will connect a Best signal JSM-AP and sync
configuration with same band automatically. When JSM-AP config changed, the JSM client will
change configuration at same time.
Wireless Network Name (SSID): This wireless network name is shared among all associated
devices in your wireless network. Keep it identical on all those devices. Note that the SSID is case-
sensitive and can not exceed 32 characters.
Brocadcast SSID: Under AP mode, hiding network name is necessary when you are in a wireless
environment that may have potential risk. By disabling broadcast SSID, the clients can not scan