Beijer Electronics korenix JetWave 3220v3 Series, User Manual

Page: 76 / 141

JetWave 3220v3/3420v3 Series User Manual
Page 67
WDS-AP : WDS mode is usually implemented in Point to Point (P2P) connection. When
configuring P2P, one end should be WDS-AP and the other end should be WDS-Client. WDS-
AP can also provide network access to general clients to act as an AP repeater.
WDS-Client : Select the WDS-Client mode. In WDS-Client mode, you must type the target WDS-
AP’s SSID and MAC address. With the setting, the traffic from the WDS-Client can Only transmit
to the WDS-AP. Please note that the rest of other wireless/security settings must the same as
the WDS-AP as well.
Primary Interface: You can select “Wlan 1” or “Wlan 2” as the primary interface. Wlan 1 is the
default primary interface.
Signal Threshold(dbm): You can assign the signal threshold value, this value is the signal
quality between the Redundant AP and Client. You can check the current value of the association
list or configure it depends on the field test or experience. Once the signal threshold of primary
interface is lower than the value you assigned, the backup interface will be activated. The default
value is -60dbm, this is an medium signal quality.
Wireless Network Name (SSID): This wireless network name is shared among all associated
devices in your wireless network. Keep it identical on all those devices. Note that the SSID is case-
sensitive and can not exceed 32 characters.
Broadcast SSID: Under AP mode, hiding network name is necessary when you are in a wireless
environment that may have potential risk. By disabling broadcast SSID, the clients can not scan