baxter Colleague 3 CXE, Operator'S Manual

Page: 125 / 230

071960491 COLLEAGUE CXE VOLUMETRIC INFUSION PUMP OPERATOR’S MANUAL
4-71
Operating Instructions
Unloading the Administration Set
Using the Manual Tube Release
Use Manual Tube Release only when the Tube Loading Mechanism is
NOT functioning, or if a channel failure occurs.
For triple channel pumps: If the Manual Tube Release is used, the
remaining pump channels cannot be programmed until the Manual Tube
Release is reset.
Never use the Manual Tube Release to load or unload the administration
set during normal operation.
1.
Close the regulating clamp on the administration set.
2.
Locate the appropriate Manual Tube Release mechanism on the right
side of the pump, when facing the front panel.
3.
Push and grasp the release tab (see Figure 4-100A), turning it out
(see Figure 4-100B).
4.
Rotate the tab counterclockwise until it stops (see Figure 4-100C).
This closes the keyed slide clamp and opens the pump mechanism.
5.
Remove the administration set from the pump.
The Reset Manual Tube Release screen may not display if a pump
failure has occurred.
If the pump is on with no administration set in the tubing channel, a
Reset Manual Tube Release
alarm occurs and the Reset Manual
Tube Release screen is displayed (Figure 4-101).
If the pump is on and the administration set is in the tubing channel
when the Manual Tube Release is activated, a
Close Regulating
Clamp
alarm occurs. Close the regulating clamp on the
administration set , remove the administration set, and then reset the
mechanism.
Note: The pump will not turn on if the Manual Tube Release
is in the open position.
A
Figure 4-100 Using the Manual
Tube Release
C
B
Note:
MTR Activation
with Pump Off
If the pump is off when the Manual Tube Release is
activated, it will automatically turn itself on. The
Reset
Manual Tube Release
alarm occurs and the Reset
Manual Tube Release screen is displayed (Figure
4-101).