baxter Colleague 3 CXE, Operator'S Manual

Page: 201 / 230

071960491 COLLEAGUE CXE VOLUMETRIC INFUSION PUMP OPERATOR’S MANUAL
11-5
Quick Reference Guide
Loading the Administration Set
1.
For single channel pumps, press the
Open
key.
For triple channel pumps, press the
Channel Select
key for the
desired channel, then press the
Open
key.
The automatic tube loading mechanism will open. The pump module
displays
PATIENT
alternating with
---->>>>
.
2.
Close the keyed slide clamp on the administration set so it occludes
the tubing.
3.
Hold the tubing so the fluid path is from left
to right (Figure 11-2a), and insert the keyed
slide clamp into the keyed slot on the
left-hand side of the tubing channel (Figure
11-2b).
4.
Pull the tubing taut and slide it all the way
into and along the tubing channel (Figure
11-2c). The pump pulls in the keyed slide
clamp, then loads the administration set into
the pumping mechanism (Figure 11-2d). The
pump module displays
LOADING
and then
STOPPED
.
Note: A
Tube Misloaded
alarm will occur if the
tubing is not loaded properly.
5.
Open the regulating clamp. Verify that no
solution is flowing.
6.
Attach the primed administration set to the
patient access site.
7.
For triple channel pumps only: Arrange the
tubing in the tubing guide according to pump
channel.
b
c
d
a
INTO
PUMP
Figure 11-2 Loading
the Administration
Set
! WARNING !
If flow is observed when tubing is loaded but the pump is not running, close the
regulating clamp immediately. Ensure that all steps have been properly
performed. If flow is still observed, remove the pump from service and contact
Baxter-trained, qualified personnel.