Baldor MintDrive, Installation Manual

Page: 114 / 155

101
A.1.3 Speed loop
The speed loop uses a Proportional and Integral (PI) algorithm. The PI algorithm is as follows:
Command =
KVP . e
+
KVI .
Σ
e
where:
KVP Proportional speed loop gain
KVI Integral gain
e Speed error
A.1.4 Current loop
The current loop uses a Proportional and Integral (PI) algorithm. The PI algorithm is as follows:
Command =
KIP . e
+
KII .
Σ
e
where:
KIP
Proportional current loop gain
KII Integral gain
e
Current error
A.1.5 MintDrive operational modes
The MintDrive can be configured to operate in 3 different modes:
H
as a servo drive, where speed and position loops are active and the motion profiler produces a
speed demand (
CONFIG=1
);
H
as a velocity servo drive, similar to the servo drive configuration above ( CONFIG=1 ) but only the
Velocity Feedforward term KVELFF is used in the position loop;
H
as a torque servo drive, where the speed loop is bypassed and the motion profiler produces a
current demand (
CONFIG=6
).
These modes are selected using the Mint keyword
CONFIG
. The default is the servo drive mode,
CONFIG=1
.
The loops are sampled at different rates:
H
Current loop: 12.012kHz
H
Speed loop: 8kHz
H
Position loop: 1kHz (optionally configurable as 500Hz and 2kHz).