Deploying Avaya IP Office™ Platform IP500 V2
Page 150
15-601042 Issue 30j (18 May 2015)
IP Office™ Platform 9.1
Comments on this document? [email protected]
12.5.1 Like for Like Replacement
If replacing with a component of the same type, no configuration changes are necessary.
To do a like for like replacement
1.
Shutdown the system
.
2. Switch off power to the system.
3. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement
must be installed in the same position.
4. Install the replacement using the appropriate process for the type of component (
Fitting IP500 cards
,
Adding
External Expansion Modules
).
5. Restart the IP Office system.
12.5.2 Higher Capacity Replacement
If replacing with a component of the same type but higher capacity, when restarted the IP Office will automatically create
configuration entries for the new trunks or extensions/users.
To replace a component with one of the same type but higher capacity
1.
Shutdown the system
.
2. Switch off power to the system.
3. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement
must be installed in the same position.
4. Install the replacement using the appropriate process for the type of component (
Fitting IP500 cards
,
Adding
External Expansion Modules
).
5. Restart the IP Office system.
6. Use IP Office Manager to configure the new trunks or extensions/users.
12.5.3 Lower Capacity Replacement
If replacing with a component of the same type but lower capacity, after restarting the IP Office the configuration will
need to be edited to remove redundant entries.
To replace a component with one of the same type but lower capacity
1.
Shutdown the system
.
2. Switch off power to the system.
3. Remove the card or external expansion module. Note the card slot or expansion port used as the replacement
must be installed in the same position.
4. Install the replacement using the appropriate process for the type of component (
Fitting IP500 cards
,
Adding
External Expansion Modules
).
5. Restart the IP Office system.
6. Use IP Office Manager to delete the trunks or extensions/users that are no longer supported by the component
installed.
12.5.4 Adding a New Component
If adding a new component to an available slot or port, when restarted the IP Office will automatically create
configuration entries for the new trunks or extensions/users.
To add a new component
1.
Shutdown the system
.
2. Switch off power to the system.
3. Install the replacement using the appropriate process for the type of component (
Fitting IP500 cards
,
Adding
External Expansion Modules
).
4. Restart the IP Office system.
5. Use IP Office Manager to configure the new trunks or extensions/users.
145
78
85
145
78
85
145
78
85
145
78
85