Avaya ERS 8600 series, Configuration Manual

Page: 283 / 420

ipv6 tunnel <tunnel id> source <A.B.C.D> address <ipv6
address/prefix-len> destination <A.B.C.D>
2. Configure the hop limit by using the following command:
ipv6 tunnel <tunnel id> hop-limit <value>
Variable definitions
Use the data in the following table to use the
ipv6 tunnel
command.
Variable Value
address <ipv6 address/prefix-len> Configures the local address for the tunneled device
in IPv6/prefix-length format.
destination <A.B.C.D> Configures the address for the device that is tunneled
to in IPv4 or IPv6/prefix-length format.
hop-limit <value> Configures the maximum number of hops that a
packet can make before it is dropped.
value is in the range 0–255.
To set this option to the default value, use the default
operator with the command.
The default value is 255.
source <A.B.C.D> Configures the address for the local device.
tunnel id Specifies the ID number of the tunnel in the range of
1-5000.
Example of configuring manual tunnels
Procedure steps
1. Configure the tunnel at the source.
ERS-8606:5(config)# ipv6 tunnel 1044 source 20.10.10.107
address 0100:0200:0300:0004:0005:0006:0000:aa01/80
destination 10.20.20.105
2. Configure the tunnel at the destination.
ERS-8606:5(config)# ipv6 tunnel 1045 source 10.20.20.105
address 0100:0200:0300:0004:0005:0006:0000:aa02/80
destination 20.10.10.107
Configuring manual tunnels
Configuration — IPv6 Routing November 2010 283