Avaya ERS 8600 series, Configuration Manual

Page: 169 / 420

Important:
Both sides of the OSPF connection must use the same authentication type and key.
Variable definitions
Use the data in the following table to use the
config ethernet ipv6 ospf
command.
Variable Value
admin-status <enable|disable> Configures the state (enabled or disabled) of the
OSPF interface.
create <area> [priority <value> ] [metric
<value> ] [retransmit-interval <value> ]
[transit-delay <value> ] [hello-interval
<value> ]
[dead-interval <value> ] [type <value> ]
Creates an OSPF interface.
• <area> is the area ID (0–2147483647) or area
IP address (0.0.0.0 to 255.255.255.255)
{a.b.c.d}.
• priority <value> is the priority in the range 0–
255.
• metric <value> is the metric in the range 0–
65535.
• retransmit-interval <value> is the retransmit
interval in the range 1–1800 seconds.
• transit-delay <value> is the transit delay in the
range 1–1800 seconds.
• hello-interval <value> is the hello interval in the
range 1–65535 seconds.
• dead-interval <value> is the dead interval in the
range 0–4095 seconds.
• type <st|nbma|p2p|p2mp> is the type of
interface where 1 is ethernet, 2 is nbma, 3 is
p2p, 4 is lookback, and 5 is p2mp.
dead-interval <seconds> Configures the OSPF dead interval for the
interface.
seconds is the number of seconds the switch
OSPF neighbors wait before determining that this
OSPF router is down. The range is from 1–
4095. This value must be at least four times the
Hello interval value. The default is 40.
delete Deletes an OSPF interface.
hello-interval <seconds> Configures the OSPF hello interval for the
interface.
Configuring port-based OSPF parameters
Configuration — IPv6 Routing November 2010 169