Avaya ERS 8600 series, Configuration Manual

Page: 172 / 420

Variable Value
router. If the priority is 0, the interface cannot become
either the designated router or a backup. The priority
is used only during election of the designated router
and backup designated router. The range is 0–255.
The default is 1.
Configuring OSPF parameters for a VLAN
Configure OSPFv3 parameters for a specified VLAN to customize your OSPF IPv6
configuration.
Procedure steps
Configure OSPF parameters for a VLAN by using the following command:
config vlan
<vid>
ipv6 ospf
Variable definitions
Use the data in the following table to use the
config vlan ipv6 ospf
command.
Variable Value
admin-status <enable|
disable>
Configures the state (enabled or disabled) of the OSPF
interface.
create <area> [priority
<value> ] [metric
<value> ] [retransmit-
interval <value> ] [transit-
delay <value> ] [hello-
interval <value> ] [dead-
interval <value> ] [type
<value> ]
Creates an OSPF interface.
• <area> is the area IP address (0.0.0.0 to 255.255.255.255)
{a.b.c.d}.
• priority <value> is the priority in the range 0–255.
• metric <value> is the metric in the range 0–65535.
• retransmit-interval <value> is the retransmit interval in the
range 1–1800 seconds.
• transit-delay <value> is the transit delay in the range 1–
1800 seconds.
• hello-interval <value> is the hello interval in the range 1–
65535 seconds.
IPv6 routing configuration using the CLI
172 Configuration — IPv6 Routing November 2010