Avaya ERS 8600 series, Configuration Manual

Page: 193 / 420

Configuring OSPF neighbor parameters for a VLAN
Configure port-based OSPFv3 neighbor parameters for a VLAN to customize your OSPF IPv6
configuration.
Important:
Both sides of the OSPF connection must use the same authentication type and key.
Prerequisites
You must log on to the VLAN Interface Configuration mode in the ACLI.
Procedure steps
Configure OSPF neighbor parameters for a VLAN by using the following command:
ipv6 ospf nbma-nbr <Ipv6address/prefix-len> priority <priority>
Variable definitions
Use the data in the following table to use the
ipv6 ospf nbma-nbr
command.
Variable Value
Ipv6address/prefix-len Specifies the IPv6 address of the neighbor as a string
of 0–43.
priority <priority> Configures the OSPF priority for the interface during
the election process for the designated router. The
interface with the highest priority number is the
designated router. The interface with the second-
highest priority becomes the backup designated
router. If the priority is 0, the interface cannot become
either the designated router or a backup. The priority
is used only during election of the designated router
and backup designated router. The range is 0–255.
The default is 1. To configure this option to the default
value, use the default operator with the command.
Configuring OSPF neighbor parameters for a VLAN
Configuration — IPv6 Routing November 2010 193