Avaya ERS 8600 series, Configuration Manual

Page: 136 / 420

Procedure steps
1. In the navigation tree, open the following folders: Configuration, IPv6.
2. Double-click
IPv6 .
3. Click the Static Routes tab.
4. In the Dest field, type the IPv6 address.
5. In the PrefixLength field, type the prefix length of the IPv6 address.
6. In the NextHop field, type 255.255.255.255 as the IPv6 address of the router
through which the specified route is accessible.
7. In the IfIndex field, indicate the Interface Index by clicking the Port or VLAN button
and selecting an option.
8. Check the enable option.
9. In the Metric field, type the LocalNextHop value.
10. In the Preference field, select the route preference.
11. Click Insert.
The black hole static route record is created in the routing table.
Enabling OSPF on a router
When you configure an interface for the OSPF protocol, you must first enable OSPF globally
on the router and then assign an IPv6 address.
Procedure steps
1. In the navigation tree, open the following folders: Configuration, IPv6.
2. Double-click
OSPF .
3. In the AdminStat option box, select enabled to activate OSPF, or select disabled to
deactivate OSPF.
4. Click Apply .
The OSPF protocol is enabled (or disabled) on this router.
5. Click Yes to confirm the forced SPF run.
The router performs the SPF run and the OSPF link state database is updated.
Important:
After initiating an SPF run, wait 10 seconds before you initiate another SPF run.
IPv6 routing configuration using Enterprise Device Manager
136 Configuration — IPv6 Routing November 2010