Avaya ERS 8600 series, Configuration Manual

Page: 323 / 420

Command Parameter
config filter acl <acl-id> vlan add <vid> [<vid2-vid3>]
remove <vid> [<vid2-vid3>]
info
config filter act <act-id> create [name <value>]
delete
apply
name <value>
info
arp <arp-attributes>
ip <ip-attributes>
ipv6 <ipv6-attributes>
ethernet <ethernet-attributes>
protocol <protocol-attributes>
config filter act <act-id> pattern <pattern-
name> add <base> <offset> <length>
name <pattern-name>
info
Configuring ACTs
Configure an access control template (ACT) to create, delete, apply, and specify attributes.
After you apply the ACT you cannot change the attributes. ACT IDs 4001 to 4096 are reserved
for system-defined ACTs.
System-defined ACTs are available for filters as required.
Important:
An ACT can use IPv4 or IPv6 attributes, but not both. You cannot combine IPv4 and IPv6
attributes in the same ACL.
Procedure steps
Configure an ACT by using the following command:
Configuring ACTs
Configuration — IPv6 Routing November 2010 323