Avaya ERS 8600 series, Configuration Manual

Page: 210 / 420

Variable Value
fwd-path <server-addr> [enable] Creates a DHCP relay forwarding path.
<server-addr> is the server IPv6 address.
Use the enable option to enable a forward path.
Use the no or default operators to delete a forward
path no ip dhcp-relay fwd-path <server-addr> default
ip dhcp-relay fwd-path <server-addr>
max-hop <1-32> Sets the maximum number of hops before a DHCP
packet is discarded (1 to 32). The default is 32.
To set this option to the default value, use the default
operator with this command.
remote-id {enable|disable} Enables or disables remote ID.
{default|no} ipv6 dhcp-relay fwd-
path <server-addr> enable To disable the specified path, use the no or default
operators with the enable option.
Showing IPv6 DHCP relay information
Display relay information about DHCP relay routes and counters.
Prerequisites
Access privExec Configuration Mode.
Procedure steps
1. Display information about DHCP relay forward paths by using the following
command:
show ipv6 dhcp-relay fwd-path
2. Display information about DHCP relay counters by using the following command:
show ipv6 dhcp-relay counters
3. Display information about DHCP relay interfaces by using the following command:
show ipv6 dhcp-relay interface <interface-type> <interface-
id>
IPv6 DHCP Relay configuration using the ACLI
210 Configuration — IPv6 Routing November 2010