Autonics AiCA Series, User Manual

Page: 90 / 131

10 Drive
90 © Copyright Reserved Autonics Co., Ltd.
10.2.2 Continuous Mode
Continuouse mode outputs pulse continuously in the designated direction until stop
command from upper level or stop signal from outside. Continuous mode and home search
mode is applicable for this funciton.
Stop commands include deceleration stop and immidiate stop. Deceleration stop is
operated when final operation spped is lower than the initial operation speed or in all cases
except for reset or emergency stop.
Continuous mode operates the motor continuously in CW or CCW direction by clicking
or button.

Continuous mode operation
1st Select ‘Continuous’ on Motion Control ‒ mode selection box.
2nd Set the ‘Start Speed’, ‘Max Speed’ value for continuous mode.
3rd Motor begins to operate to designated directon by clicking or button.
4th Operation stops by clicking button or when the designated direction limit
signal is applied.

Start Speed, Max Speed, Accel Rate and Decel Rate can be loaded from the saved value
without entering these values.