Autonics AiCA Series, User Manual

Page: 6 / 131

Safety Considerations
vi © Copyright Reserved Autonics Co., Ltd.
Safety Considerations
 Following these safety considerations will ensure the safe and proper use of the
product and help prevent accidents, as well as minimizing possible hazards.
 Safety considerations are categorized as Warnings and Cautions, as defined below:
Warning
Failure to follow these instructions may result in serious
injury or death.
Caution
Failure to follow these instructions may result in
personal injury or product damage.

Fail-safe device must be installed when using the unit with machinery that may cause
serious injury or substantial economic loss. (e.g. nuclear power control,
medical equipment, ships, vehicles, railways, aircraft, combustion apparatus, safety
equipment, crime/disaster prevention devices, etc.)
Failure to follow this instruction may result in personal injury, economic loss or fire.
 Do not use the unit in the place where flammable/explosive/corrosive gas, humidity,
direct sunlight, radiant heat, vibration, impact or salinity may be present.
Failure to follow this instruction may result in explosion or fire.

Do not connect, repair, or inspect the unit while connected to a power source.
Failure to follow this instruction may result in fire or electric shock.
 Install the unit after considering counter plan against power failure.
Failure to follow this instruction may result in personal injury or economic loss or fire.
 Re-supply power after min. 20 sec from disconnected power.
Failure to follow this instruction may result in product damage or malfunction.

Check ‘Connections’ before wiring.
Failure to follow this instruction may result in fire.

For installing the unit, ground it exclusively and use over AWG 18 (0.75mm
2
) ground
cable.
Failure to follow this instruction may result in electric shock.

Do not disassemble or modify the unit.
Failure to follow this instruction may result in fire or electric shock.
 Insulate the connector not to be exposed.
Failure to follow this instruction may result in electric shock.
 Install the driver in the grounded housing or ground it.
Failure to follow this instruction may result in personal injury, fire or electric shock.
 Do not touch the unit during or after operation for a while.
Failure to follow this instruction may result in burn or electric shock due to high
temperature of the surface.
 Do not remove the connector during or after operation for a while.
Failure to follow this instruction may result in electric shock or product damage.

Emergency stop directly when error occurs. Failure to follow this instruction may result
in personal injury or fire.