Automationdirect.com Stellar SR44, User Manual

Page: 79 / 238

5–5
5.1.3 – System Status Mode
Following the initial boot-up report (see section 5.1.9), the unit enters the Status Mode. In this
mode the operating status of the unit is constantly displayed, resulting in a number of status
messages:
Non-Running Status
Two messages indicate that the unit is not running the load at present. ‘Stopped and Ready’
indicates the unit is enabled, and ‘Starter Disabled’ indicates that the unit is disabled. (See
Appendix A.1.2).
Fault number Fault description
This message indicates that a fault has occurred, giving the fault number and a short fault
description such as ‘#1 Phase Loss’. The second line of the message tells the user to reset the unit
with the # key.
Temporary Comms Status Errors
These messages, (‘CRC Error’, ‘Slave Busy’, ‘Illegal Address’, and ‘Illegal Function’) tell the user
when there has been a Modbus Comms Error. (See the Modbus chapter for more details.)
Running Status
This message indicates which running mode the unit is in either, ‘Starting’, ‘Full Volts’, or
‘Optimizing’. The second line of the message gives a current indication in Amps. If an overload
condition exists, then a bar graph indicating the state of overload integration will be shown across
both lines on the right hand side of the display.
5.1.4 – Menu Navigation Mode
The Menu Navigation Mode is entered as soon as the ENTER button is pressed in the System Status
Mode. In this mode, the user can navigate through all levels of the menu structure using the
relevant buttons on the keypad. (See Figures 5.1.2a & 5.1.2b).
Chapter 5: Keypad Menu Items and Parameters
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019