Automationdirect.com Stellar SR44, User Manual

Page: 119 / 238

5–45
5.4.8 – ‘Password’ Menu
Enter Password
Range: 0 to 255 Default: 0 Scaling: n/a Type: R/W
‘Password’ is used by the keypad; Keypad sees 0s as no password set.
This option enables the user to temporarily unlock a unit by entering a previously set password.
When the unit is ‘locked’, the user can read all parameters as usual, but the user cannot write to
any parameters. The unit can be started and stopped while it is locked. (See Appendix A.1.10a).
Change Password
Range: Default: 0
‘Change Password’ enables the user to change a previously set password, to enter a password for
the first time, or to clear the password. If the password is non-zero, then you must unlock the
password using “Enter Password’ previous to using ‘Change Password.’ This last action (clear
password) is performed by changing the password to zero (0) and pressing Enter. This action clears
any set password, but the control supply must be cycled or the unit reset by pressing the
쑿
and
쑼
buttons at the same time after the password has been cleared. (See Appendix A.1.9).
(P-5)
–
Chapter 5: Keypad Menu Items and Parameters
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019