Automationdirect.com Stellar SR44, User Manual

Page: 46 / 238

3–2
1st Ed, Rev B 07/31/2019
SR44 Series Soft Starter User Manual
3.1 – Motor Suitability and Associated Considerations
The SR44 Soft Starter is based on a series of microprocessor-based optimizing soft starters which
have been used world-wide in more than 100,000 critical and non-critical systems. Since 1983,
these soft starters have successfully operated with almost every type of load and environment from
the Antarctic to the Jungle. The design has proven to be both reliable and adaptable, and provides
a powerful mechanism with which to control fixed-speed induction motors.
However, due to the intrinsic differences between electronic and electro-mechanical starting
systems, there are a number of simple rules and observations to follow when using the SR44 Soft
Starter. This section introduces guidelines for the user and those incorporating the unit as part of
their system design.
3.1.1 – Suitability
In principle, any three-phase induction motor can be started by a soft starter. Normally, the
breakaway torque of the load should be less than the full-load torque of the motor, unless a motor
with a high locked-rotor torque characteristic is employed. As a quick assessment, any load which
has a low or no-load start with a moderate starting time, or which can be started with a star-delta
(wye-delta) starter, auto transformer or other forms of reduced-voltage starting, can be considered a
potential application for a soft starter.
3.1.2 – Induction Motor Characteristics
Three-phase induction motors are required to provide sufficient torque to accelerate the motor and
its load from standstill to full speed, and to maintain full speed efficiently at all torque levels up to
the design full-load torque. Most modern three-phase induction motors have characteristics that
are wholly suitable for use with soft starters. However, the characteristics vary considerably
between different manufacturers and design types.
It is important that the motor is capable of providing sufficient torque to drive the load at all
speeds from standstill to rated speed, to enable the SR44 to function properly. It is particularly
important that the motor to be soft started does not have a low pull-up or saddle torque, or the
load may not be accelerated correctly.
The primary function of the soft starter is to act as a torque-regulating device. It cannot apply a
torque greater than that which the motor generates. For this reason, problematic applications for
which many different starting methods have been tried but failed may need analysis of the motor
or load performance before a soft starter can be successfully applied.
3.1.3 – Rating
For most applications, except high inertia loads, the starting demands and the inertia of the
rotating masses are small enough to be insignificant. This means that no special consideration
needs to be given to the rating of the soft starter, other than to ensure that it is equal or marginally
greater than the rated voltage and current of the controlled motor.
Alternatively, if the number of poles of the motor and the moments of inertia of the load (J
load
) and
motor rotor (J
motor
) are known, a soft starter will be suitable if the figures comply with the criteria
given in the bottom row of Table 3.1.3.
Section 3.2.13 contains a table showing the more common applications.
Table 3.1.3
Number of Poles 2 4 6 8
Synchronous Speed (rpm @ 60 Hz) 3600 1800 1200 900
(J
load
)/(J
motor
) less than 5 15 20 25
Chapter 3: Applications