Automationdirect.com Stellar SR44, User Manual

Page: 200 / 238

Appendix A: Setup Examples
A.1.4 – Changing from ‘Keypad Starting’ to ‘Remote Starting’
With ‘Keypad Starting’ set, the unit is started from the keypad or remote keypad. While ‘Remote
Starting’ is set, the unit is started with a start signal between S0 and S1. ‘Keypad Starting’ is the
factory default value.
1. With ‘Stopped and ready’ shown on the display, press the ENTER.
2. With ‘Applications’ shown on the top line of the display, press
쑼
button until ‘Basic’ is shown
at top of display.
3. Press ENTER to select ‘Basic’ menu.
4. With ‘Starting’ shown at top of display, press ENTER to select the ‘Starting’ option.
5. With the display now showing ‘Starting’ on the top line, press ENTER to toggle the bottom line
of display from ‘Keypad Starting’ to ‘Remote Starting’.
6. At any of the above stages, pressing # will return the user to the previous menu.
7. The SR44 will now start and stop remotely from the customer’s switches (see section 2.3.1 of
Electrical Installation), but will return to ‘Keypad Starting’ if the control supply on terminals X1
and X2 is removed and a ‘Save Param’ has not been performed. Alternatively, to return to
‘Keypad Starting’, repeat the above procedure and select ‘Keypad Starting’ at step 5. To keep
the ‘Remote starting’ setting after removal of the control supply, the settings must be
permanently saved (See section A.1.5).
Enter
#
Enter
#
1
2
3 4
5
6
#
6 6
(press button multiple times, or hold to scroll)
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019
A–6