Automationdirect.com Stellar SR44, User Manual

Page: 199 / 238

A–5
Note for A.1 Setup Examples
A.1.3 – Loading the ‘Large Pump’ Application into Memory.
There are a number of pre-programmed applications included in the SR44 for speed and ease of
setup. The parameters loaded by each selection characterize the standard setup of each particular
application.
1. With ‘Starter Disabled’ shown on the display, press the ENTER button.
2. With ‘Applications’ shown on the top line of the display, press the ENTER button.
3. With ‘Settings’ shown at the top of the display press
쑼
button until ‘large pump’ is shown at
top of display.
4. Press ENTER to select ‘large pump’. The display will indicate which parameters are to be
changed.
5. With the top line of the display showing ‘Send to store?’, press ENTER to save the settings for a
‘large pump’. (If the # button is pressed instead at this point the unit will flash the message
‘Cancelled’ three times). The display will flash the message ‘Storing’ twice to indicate this has
been done.
6. At any of the above stages, pressing # will return the user to the previous menu. The unit will
not start until the display indicates ‘Stopped and ready’.
In the following examples, the default parameters are assumed to have been loaded before the start of the
example, unless otherwise stated. This is to provide a common reference point for the instructions.
This example assumes that the unit has been disabled (see section A.1.2).
There is no need to save the changed parameter values, as they are automatically saved at instruction 5.
#
Applications
Auto Features
Enter
Starter Disabled
1: To Enable
Large Pump
Conveyor
#
Send to store?
#=No Enter=yes
1 2
3
4
5
#
Settings
Default (keypad)
St oring
6 6
6
Cancel led
Enter Enter
Enter Enter
(press button multiple times, or hold to scroll)
Appendix A: Setup Examples
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019