Automationdirect.com Stellar SR44, User Manual

Page: 125 / 238

5–51
5.4.11 – ‘Parameters’ Menu (continued)
Status 2
Range: 0 to 99 (flags) Default: 0 Scaling: 1 Type: R
‘Status 2’ flags – Read this parameter by individual bits.
• Bit #:
0: Alarm – starter has detected a Fault and has tripped.
1: Overload Integrating – onboard overload has detected Overcurrent and is integrating.
«•» This parameter bit is not available in Bypass Operation unless a user-supplied external current
transformer is installed. (Refer to P18/B2, ‘Auto Bypass’.)
2: Stall – starter has detected that motor speed is slipping.
«•» This parameter bit is not available in Bypass Operation unless a user-supplied external current
transformer is installed. (Refer to P18/B2, ‘Auto Bypass’.)
3: Forced Override – starter has turned off optimizing since the current has risen above 80% FLC.
4: Noise – starter is experiencing poor mains reference signals.
5: Inhibit Start – Start is Inhibited for a period to keep the unit within its allowable start duty.
6: DC I/p Level Reached – DC I/p has risen above the level specified in parameter 48.
7: Reserved
Status 3
Range: 0 to 255 (flags) Default: 0 Scaling: 1 Type: R
‘Status 3’ flags – Read this parameter by individual bits.
• Bit #:
0: K1 – Relay K1 Status
1: K2 – Relay K2 Status
2: (unused)
3: (unused)
4: I/p 1 – Input 1 Status
5: (unused)
6: (unused)
7: (unused)
P-9
P-10
Chapter 5: Keypad Menu Items and Parameters
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019