Automationdirect.com Stellar SR44, User Manual

Page: 206 / 238

Appendix A: Setup Examples
A.1.10a – Unlocking and Locking the Keypad
1. With ‘Stopped and ready’ displayed, press the ENTER button once.
2. With ‘Applications’ shown on the top line of the display, press the
쑼
button until ‘Password’
takes its place on the top line.
3. Press ENTER once to select the ‘Password’ menu.
4. Press ENTER with ‘Enter Password’ shown on the top line of the display. The unit will display
its security status, ‘Locked’ on the bottom line of the display. A cursor will also be visible on
the bottom line of the display.
5. Use the
쑿
or
쑼
button to enter the password.
6. Press the ENTER button once.
7. If the correct password has been entered, the unit will display its security status, ‘Unlocked’ on
the bottom line of the display. To lock the unit again, simply use the
쑿
or
쑼
buttons to enter
any value, apart from zero (0), and the password. Press the ENTER button once and the display
will now say that it is ‘Locked’.
8. Press the # button three times to return to ‘Stopped and ready’.
A.1.10b – Clearing the Password
1. Press the
쑿
and
쑼
buttons simultaneously to reset the password.
2. Once the display has flashed, press and hold the
쑼
button until ‘# to reset’ is displayed.
Do NOT press ‘# to reset’.
3. Press the
쑿
button once.
4. Press the
쑼
button once.
5. Press ENTER.
6. Display shows ‘BingoØ?’.
7. Press ENTER.
8. Display will show ‘Comms Failure’.
9. Cycle power to the SR44, and all parameters will be reset to factory defaults.
Enter
#
Enter
#
1
2
3
4
5
6
8
7
#
8
8
(press button multiple times, or hold to scroll)
(press button multiple times, or scroll)
If the control supply on an un-locked unit (i.e., the password has been set previously and then entered to
unlock the unit) is cycled, upon reboot the unit will be in a locked state.
Conversely, if the password has never been “Changed” from zero, cycling power will unlock the SR44.
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019
A–12