Automationdirect.com Stellar SR44, User Manual

Page: 218 / 238

Appendix A: Setup Examples
A.2.4 – Selecting Optimizing with Programmable Input 1 (continued)
(continued from previous page)
9. With ‘Map To’ on the top line of the display, press the
쑼
button once until ‘Bit Number’ is
displayed.
10. Press ENTER once to select ‘Bit Number’.
11. Press the OPTIMISE button four times so that the cursor moves to bit 4.
12. Press the
쑼
button once to change the bit state of bit 4 to zero (0).
13. Press the OPTIMISE button three times so the cursor moves to bit 7.
14. Press the
쑿
button once to change the bit state of bit 7 to one (1).
15. Press ENTER once to accept the change. The display will flash once to confirm that the
change has been accepted.
16. Press # once to return to ‘Bit Number’.
17. With ‘Bit Number’ on the top line of the display, press the
쑼
button until ‘Polarity’ is
displayed on the top line.
18. Press ENTER once to select ‘Polarity’.
19. With ‘Positive Logic’ displayed, press ENTER once to change to ‘Inverse Logic’. The display
will flash once to confirm that the change has been accepted.
20. Press # four times to return to ‘Stopped and ready’.
10
9
11
12
13
14
15
16
#
17
18
19 19 19
20
20
(continued from previous page)
To keep the above settings, they must be permanently saved. See section A.1.5
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019
A–24