Automationdirect.com Stellar SR44, User Manual

Page: 205 / 238

A–11
A.1.9 – Changing a Password
1. With ‘Starter Disabled’ displayed, press the ENTER button.
2. With ‘Applications’ shown on the top line of the display, press the
쑼
button until ‘Password’
takes its place on the top line.
3. Press the ENTER button to select the ‘Password’ menu.
4. Press the
쑼
button, and ‘Change Password’ will be displayed on the top line.
5. Press ENTER to select ‘Change Password’. A cursor will be visible on the bottom line of the
display.
6. Use the
쑿
or
쑼
button to enter a new password number.
7. Press the ENTER button once.
8. The display will flash ‘New Password!’ twice to confirm that the change has been made.
9. Press the # button three times to return to ‘Starter Disabled’.
Enter
#
Enter
#
1
2
3
4
5
6
#
9
8
7
9
9
(press button multiple times, or hold to scroll)
(press button multiple times, or scroll)
Notes:
1) The unit must be unlocked (section A.1.10) in order to change the password.
2) Setting the password to zero (0) deletes any set password, and leaves the unit unlocked AFTER the
control supply has been cycled or the keypad / remote keypad has been reset.
3) It is not necessary to save the password since it is stored automatically every time that its value is
changed.
This example assumes that the unit has been disabled (see section A.1.2) and, if necessary, has already
been unlocked (see section A.1.10).
Appendix A: Setup Examples
SR44 Series Soft Starter User Manual
1st Ed, Rev B 07/31/2019