Ashida ADR241B, Instruction Manual

Page: 154 / 272

ADR241B
Doc ID : ADR241B-DO_IM_01
Ref ID : ADR241B/IM/UG
Rev No. : 06
Page No. : 154 of 272
Then the control will automatically move to next option.
IAMAG = 00000
IBMAG = 00000
This window shows actual Primary load current as per the CT
Primary selection.
NOTE: This will also clear all fault memory.
8.3 MENUS
8.3.1 Default Display
After the Power ON or when the TARGET RESET + PROT. RESET key is pressed, the
relay will display the following message.
Ashida OC/EF Rly
ADR241B_V2_R1
This window will flash momentarily showing the following.
Relay Type: Ashida Digital O/C EF Relay
Then the control will automatically move to next option.
IAMAG = 00000
IBMAG = 00000
This window shows actual Primary load current as per the CT
Primary selection.
8.3.2 Main Menu Details
IAMAG = 00000
IBMAG = 00000
Default window, shows actual Primary load current as per the
CT Primary selection.
Press the Left arrow key (

) to move to the Main Menu
MEASUREMENT
This menu is to view the measured and derived actual load
current as per CT Primary and Secondary current selection, I2/I1
Ratio and Thermal State.
Press the Plus / Up arrow key (+ /

) to move to the next option.
General Setting
Password protected window for “ General setting” i.e. New
Password, Unit ID, Com Port, Set RP Parity, Set RP Baud
Rate, Frequency, PH CT Secondary, PH CT Primary, EF CT
Secondary, EF CT Primary, TCS Enable, TCS Delay, 50 BF,