Ashida ADR241B, Instruction Manual

Page: 159 / 272

ADR241B
Doc ID : ADR241B-DO_IM_01
Ref ID : ADR241B/IM/UG
Rev No. : 06
Page No. : 159 of 272
MEASUREMENT
8.3.4 GENERAL SETTINGS
8.3.4.1 To Set – General Settings
General Setting
Password protected window for “ General Setting’’ setting i.e.
New Password, Unit ID, Com Port, Set RP Parity, Set RP Baud
Rate, Frequency, Ph CT Secondary, Ph CT Primary, EF CT
Secondary, EF CT Primary, TCS Enable, TCS Delay, 50 BF,
50 BF Delay, 50 BF_I, 50 BF Reset, Active Group, DR Pre-Trig
time, LocalCntrlEnable and ETH Protocol.
Press the Left arrow key (

) to move to the next option.
Password
0000
Editable setting
Enter the previously set password, by using the up arrow key
(+ /

) or the down arrow key (- /

).
Note: Default password setting is ‘0000’
Press the Left arrow key (

) to move to the next option.
New Password
0001
Editable setting
By using the Plus / Up arrow key (+ /

) or the Minus / Down
arrow key (- /

) the desired New Password can be set.
The setting range is from 0000 to 9999 in step of 1.
Press the Left arrow key (

) to move to the next option.
Unit ID
001
Editable Setting
By using the Plus / Up arrow key (+ /

) or the Minus / Down
arrow key (- /

) the desired Unit ID can be set.
The setting range is 001 to 250 in step of 1.
Press the Left arrow key (

) to move to the next option.
Com Port
USB
Editable Setting
By using the Plus / Up arrow key (+ /

) or the Minus / Down
arrow key (- /

) the desired Com Port can be set i.e. USB /