Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
22
In the automatic function interface, press key
【
F3
】
(Back) to make the machine go
backward along with the original trail. When the torch reaches the position you need,
press “STOP” key to stop it. You may press key
【
F2
】
to go forward if the machine
just went back too much.
Notice: Go backward or forward function can be used repeatedly to make the machine
reach an ideal position.
When the torch reaches the position you need, press “START” key again, if the
current cutting code is G01, G02 or G03, system will automatically perforate before
performing these procedures, and then continue the current program, if the current
row is not G01, G02 or G03, the system will directly continue the current line program.
3.5 Edge Cutting / Offset Cutting / Return
When the torch is not on the actual path of the current work piece, it will prompt as follows:
F1 Back
F2 Demo
F3 Frame
F4
Speeddown
F5 Speedup
F6
Preheatdown
F7
Preheatup
F8
JumptoPierce
FLSK F2200B
Version
3.3.71.1
Speed:
00000
File:
SHAPE_43.TXT
Status:
Stop
Current Line/Hole:
00000/00000
+X:500.00 -X:0.00 +Y:500.00 -Y:0.00
1:
（
TEST PATTERN
）
2
：
G92
X
：
+000000.0
Y
：
+000000.0
Manual
【
F
】
StepMov
StepDis
【
G
】
5.00 Flame Cu
【
M
】
CutSpeed
【
X
】
300.00 Kerf
【
N
】
1.20
ManualSpeed
【
Y
】
3000.00 Angle 0.00
[G]Cutting return
[X]Offset cutting
[Y]only return
●
Ignition s
●
LowHeat s
●
HighPreheat s
●
Pierce1 s
●
Pierce2 s
●
Pierce3 s
●
TorchUp s
●
TorchDn s
●
THC En
●
Blow s
Fig. 3.3 edge perforation
There are two reasons led to this situation:
