Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
60
Position up Time: Enter any positive number, unit is s. Before positioning check, the
time for the torch to lift up.
Close arc: In setting the rate of X%, open the output port, close the arc press signal, to
prevent the steel melting under low-speed cutting tip due to temperature is too high.
Distance to close arc: in the minimum distance of the cutting line of the initial
segment or end segment, close the arc voltage increases.
Lose arc delay: detect the delay time of the feedback of the broken arc, if there’s
still no arc voltage input, the situation is considered to be broken arc. This
parameter can effectively avoid the arc broken alert because of the sensitivity of the
broken arc detection in the cutting methods with lead, this guarantees the
continuousness of the cutting and avoid the interrupt of frequent alert .
Watch arc enable: whether real-time detection of arc voltage signal in cutting process
or not.
If setting "yes", in the cutting process, the system detects he real-time arc
voltage feedback signal. If do not detect the signal, the system will stop the
current workpiece cutting and transmit alarm signal.
If installing a "No", then in the cutting process does not detect arc voltage
feedback signal.
7.4 Powder Parameters
As the figure 7.4 shows, it is powder parameters of system about the powder paint line.
